450 Auto to Manual 127mm: Infinity Focus

Because I am now using the film part of this camera, it is best to make sure the compartment is good. In this case, the foam seals were crumbling and needed replacement.

low-density foam
image-1561

low-density foam

Low density foam from a hardware store is all it takes.

bend tab back down, all done
image-1562

bend tab back down, all done

Bend up the metal tabs, insert foam, bend down metal.

The film pack will now be well seated.

5-infinity
image-1563
To test this perfection you’ll need some ground glass. Ground glass makes a bright image you can see in almost direct sunlight. If you don’t have any, a piece of tracing paper will work fine, you’ll just need a hood to see the dimmer image.

Attach the camera to a tripod and set it up to focus on something at least 50-75ft away.

Use the T setting of the shutter to keep it open while you work, set the fstop to the largest opening.

Use the finder to make sure what you are focusing on is infinity and far enough away.

Compare what you see in the finder to the ground glass. In this case, as expected, the camera is spot on.

If yours is not on, see which direction the lens needs to move, forward or back. Compensate with shims on the front of the board, or grinding out some to allow the lens to sit further back.

Worst case scenario is that somewhere in the middle, focus will be slightly off. However, setting the lens to at least f11, will solve that problem.