250 Auto to Manual 105mm: Lensboard

remove bellows screws

remove bellows screws

This entire project is pretty much just adapting this lensboard to fit the new lens and shutter.

Many automatic Polaroid cameras of this type have plastic rivets instead of actual screws holding the bellows to the lensboard.

Metal body models, like the 250, use screws.

 

bellows pulled back

bellows pulled back

The bellows are an important part of this camera, keeping it safe is a priority.

You’ll notice the cable release and battery wire still keep the bellows attached.

2 - battery

cutting the battery wire

cutting the battery wire

Since this camera will no longer need electrical power, remove the battery and its clip by taking out the single screw.

Cut the two battery terminal tips off. Pulling the wire a bit reveals a brass fitting which keeps the wire from being pulled out the front of the camera. Snip here.

With the fitting removed, you can now pull the wire through the front, and the 2 loops on the bellows.

With the fitting removed, you can now pull the wire through the front, and the 2 loops on the bellows.

With the fitting removed, you can now pull the wire through the front, and the 2 loops on the bellows.

Just the cable release and metal arms are left before freedom!

The last attachments are the 3 points held by the metal arms.

The top and the bottom are connected by a single metal rod going through the lensboard.

The last connection is to a spring within a slide slot.

bottom screw and bolt

bottom screw and bolt

The spring arm sits within a slide held to the lensboard with a screw and by a small bolt.

Removing the bolt will cause a metal rod and washer to fall out.

2 - parts

The top and bottom are connected by this metal rod, unscrewing one or the other will cause both to fall out. Save these parts and remember the order in where they go.

Now slack, you can unhook the spring too.

cable release removal

cable release removal

Only the cable release holds the lensboard prisoner.

Remove the screws and it can be removed.

The larger top screw is one of the 3 that hold the 2 halves of the lensboard together.

Keep this one.

the body, all alone"

the body, all alone”

Now free of the camera body, the lensboard can be worked on exclusively.

lensboard screws

lensboard screws

Three screws and the stuck label on the top, hold the lensboard together.

First was the shutter release, the last two are on the back.

both halves

both halves

Once apart you will have two halves. One has nothing but some foam and a single lens.

The other contains everything that IS this camera.

The electric eye, the chips and resistors, all that junk, its in here.

But who cares, lets rip it out of there.

circuit screws

circuit screws

The circuitry is held by 4 screws.

circuits removed; electric eye shade

circuits removed; electric eye shade

Once removed you can see all the fancy doo-dads that made this baby tick.

On the lensboard you can see the mechanism behind “lighten/darken”.

Toss the circuits and set the front piece aside.

pry the lens ring out

pry the lens ring out

The back lens element is held in with a small retaining ring.

Use a flat screwdriver to pop it out.