Automatic 350: Batteries

These steps show how to convert to cheaper and more easily found batteries.

The battery compartment for these cameras is on the left side of the back. A little notch towards the top lets you know where to open from.

5 - batteriesBasically these double 3v models take a really odd looking batteries with snaps (what you have on typical 9v batteries). Expect to pay $9 plus shipping if you find one. And its still going to be alkaline; less life than a lithium.

More than likely the batteries are dead, corroded, and probably both. Surprisingly this model, they looked ok.

Remove the batteries and cut the end snaps off.

battery compartment screws

battery compartment screws

Clean the compartment with some alcohol and swabs.

Remove the two screws holding the battery clip.

With single battery compartments you’d normally have to remove the entire plastic compartment, but with a dual battery model, you only remove the battery clip.

find shutter & timer wires; remove everything else

find shutter & timer wires; remove everything else

There are still some odd contacts and wires left. Its quite obvious which leads to the timer, but the shutter is another matter.

Look inside and notice 2 wires coming from the front of the camera. These are the ones you must connect to.

Another pair comes from the back door and is for the timer should you want to power it.

All other wires, regardless of their connection, should be removed.

To make sure your camera will even function with a new battery, get yourself a 3v source. Be it a 2xAAA holder or a 3v lithium holder. Connect the shutter wires to it temporarily. Cock the shutter. With something covering the electric eye, push the shutter button and hold it. You should hear a single click. Wait a second or two, and remove your finger from the eye. If you hear a second click soon after, the camera is working. If you only hear 2 very fast clicks no matter what you do, the power is not reaching the circuits.

One click is the shutter opening, the second is it closing. Test different lighting situations and listen for the differences in timing. Bright light should make the clicks closer together than a dark place.

While I chose to mod this one to 3v photo lithium (CR123-size) batteries, if you feel you do not need the electronic timer, you can still use 2xAAAs.

However, there is simply not enough room to fit 4xAAA batteries in there so if you want both the timer, you only choice is to use 2x3v lithiums.



CR-123 sized battery and holder

CR-123 sized battery and holder

You’ll find these batteries in any store that sells batteries. The holder would be a little more difficult, Google can be your friend for those. Both can be had for under $9 total and will dramatically increase the time between battery changes.

soldered and sealed

soldered and sealed

Strip the 2 wires for both the shutter and timer. I found using an xacto knife and shaving the covering to be best, the wires are flimsy. Using a soldering iron, tin the tips with some solder and flux. Do the same to the 2 terminals of the battery holders. You may need to lengthen one set of wires to get it to reach the top of the compartment.

Solder the white wire to positive, the black wire to negative. Just for cleanliness sake, use some hot glue to seal the connections.

glued in place

glued in place

Turn the holders a few times to keep twist the wires together.

Test fit the battery holders next to each other. They should only fit in one configuration.

Make sure you can still close the door. Use more hot glue along the right side and bottom of the compartment to hold them fast. I also like to seal the side edges.

And you are done!